![]() JM-120: 500 Series Direct Instrument Pre-ampĭual Hi-Z input DI Pre Amp, One common Output. Current requirements: +16.5V less than 75mA, -16.5V less than 35mA.Distortion: +15dB Out 1.5KHz +15dB out 1.5KHz reduction.Noise: -98.2dB Below 0dB(.775V) unity gain, 20 to 20KHz filter.Now I need a rack full of them!” Johnny Sandlin I really like it on vocals, sounds good on acoustic and electric guitars as well. Even at more severe compression the sound is the same, very smooth and natural. It helps control the level of the source without changing the sound. “The JM 115C is one of the very best compressors I’ve ever used. It does not pad the input (reduce level) before compression, allowing maximum dynamic range from your mic pres ect.Īvailable in either the 500 Series module or the stand alone that will run off the same supply as the JM-130 mic pre. ![]() The JM-115C has a very short and direct signal path allowing for very low distortion and very low noise, it’s a very clean transparent compressor. Like the 160VU the JM-115C is very easy to set up, simply start at a low ratio, set the threshold around +4 to +10dB and output where needed to get the level to tape you need.! ![]() Compression ratio starts at a very low 1.25:1, for a very small amount of compression, preventing clipping the recorder input but not over compressing. The JM-115C is a Transformer coupled In/Out VCA based compressor using true RMS detecting similar to the DBX 160VU.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |